Sunday 19 February 2017

F10: Rear Parcel-Shelf Swap / Replacement

The original parcel-shelf was in a sorry state, with several rectangular slots cut in it where Police lights had been fitted. The two in the below picture were glaring at me every time I looked in the rear-view mirror and third, twice the size and facing the rear, could be seen clearly from outside. Despite not being one of the first things to get replaced, it became my biggest concern with the interior and has ended up being the piece that has made the most difference to the car's appearance.

A mint and very clean  replacement was £60 from eBay and came with the speakers, grilles and all trim pieces, handy as mine was missing some.


FITMENT:

1. Remove the rear-seat squab by pulling the front edge up sharply at either side and sliding it forward.

2. Remove the 3 bolts holding the bottom-end of the rear seat-belts to the body using a T45 Torx-socket.
3. Remove the rear-seat back-rest by undoing the 2 bolts holding the bottom brackets in place using a T45 Torx-socket and lifting it vertically up off the upper brackets.
4. Remove the 5 plastic-clips holding the leading-edge of the parcel-shelf by prising the centre-pin out with a flat-screwdriver [or ideally a trim-tool] and then prying the clip out.

5. Loosen both of the C-pillar trims. They are only clipped on and should pop off easily enough at the bottom. They do not need to be completely removed, just loose enough to allow the lip at either side of the parcel-shelf to slide in and out.

6. Slide the parcel-shelf forward partially, pop the seat-belts through the apertures and disconnect both speaker wires. The parcel-shelf can now be fully removed.
7. Swap trims/speakers over to new parcel-shelf.
8. Reverse steps 1 - 6 to refit.