Friday, 14 March 2014

E60 Audio: RCA Feed from Rear Speakers - quick n dirty guide.

**Caution: This guide is fir fitting extra component/coaxial speakers and is NOT suitable for fitting subs as the rear-speakers receive no low-end frequencies. If you are fitting subs then see THIS GUIDE on getting bass-RCA from the stock-subs.

This guide covers a very quick and easy way to get an RCA-feed into the boot on your BMW E60 and other iDrive models. This method is only suitable if you are fitting extra component or coaxial speakers [inc. 6x9s etc.] where the range of frequencies handled by the rear speaker-EQ are required.

PROCESS:

** If you are fitting extra component/coaxial speakers then adding a crossover-box to the RCA-feed before the amp should not be necessary. If you intend to use a crossover, substitute the 4 wires of the Red/White RCA-cable in this guide for 4 lengths of normal wire and see THIS GUIDE on how to install it.

1. Take a normal Red/White stereo RCA-cable, cut both plugs off from one end and separate the two wires down most of its length. An RCA-cable of about 4 feet should be plenty to reach up to both rear-speakers.

2. Carefully unwind the earth-wire from around each coated-wire and twist them off, so each of the coaxial RCA-wires is now split into two, as shown.


3. Bend each of the four wires over about 5mm from the end and completely sheathe the two bare earth-wires up to here, so they are well separated from the red/white live wires, as shown.


4. Gently prise off each rear-speaker grille using a flathead screwdriver, starting at the front edge.

5. Remove the 3 screws holding each rear-speaker using a T20 Torx-head wrench/driver, then lift out and unplug both speakers.

6. From inside the boot, light can be seen coming in through the empty speaker-recesses. Route one cut end of the RCA-cable up into each speaker-recess. They should easily be reached now from the parcel-shelf.

7. Splice the coated live-wire of the RCA-cable to the + speaker-wire on each side and the bare earth-wire to the - speaker-wires. The colours are as follows:

O/S - Yellow/Black +, Yellow/Brown -.
N/S - Black/Red +, Black/Purple -.


8. Push the wires down into the parcel-shelf and replace the speakers/grilles.

Done in 5 minutes!


No comments:

Post a Comment